![]() I also use it on the inside faces adjacent to the joint as a glue barrier. I use tape on the outside corners to help align the miters. When gluing up small boxes and/or frames, I've taken to using masking tape (packing tape works well for larger work). Note: My assumption is that end grain would absorb dye/stain differently and result in bleed down the sides, but I'd have to test to be certain. A 36" length ($3.38) would result in around 40 squares if cut to a 3/4" thick and the orientation would result in the display sides being end grain. Another option is to buy 1" square stock from a big box store and then slice it into your desired thickness. Options Cutting the 1" squares from plywood like this basically results in the two display sides being face grain, which is the same orientation I would've had if I had used 3/4" poplar board stock. You could use a bandsaw with a fence and backing block or miter gauge set up, but I prefer the table saw. ![]() ![]() Second step was to cut the 1" strips into 1" squares using a small parts crosscut sled with a stop block. I noticed some voids in the plywood and knew I'd have some throwaways due to veneer chip out, so I cut extra stock. First step was to cut the plywood into 1" strips. I considered 16x16 (256) and even 32x32 (1020), but 169 seemed like an adequate amount of pain for prototyping. A 13x13 field requires 169 individual squares. The box store labels it as "blondewood," so it's probably poplar as well. Fortunately for me, I had a stack of plywood which was very clear and consistent. I planned on using 3/4" poplar board offcuts for this project, but my available selection contained too much variation (greens, purples, gnarly grain) and not enough of any one tone. This play area could be reduced by starting with a border, while being large enough so that it won't immediately be outgrown. 11-13 pixels squared seemed like a good starting point. "The Kid" is 6 years old, so I wanted to start with a smaller field. They could be placed randomly to create random or repeating patterns, but they could also be used to mimic simple pictures. The only variables are a choice between black and white and where to place each cube. Instead of uniquely shaped pieces, they would all be identical. ![]() My idea was to create a game or puzzle based on pixel art. Translation: too many choices and opportunities for failure. but my leading theory is that he's overwhelmed by all the different parts and possibility of improper assembly. In fact, The Warden will tell you I don't behave at all. He had absolutely no problem finding the proper parts, he just didn't want to put them together. I tried to make it less intimidating by knolling the parts and gathering what was necessary for each step, but he didn't take the bait. The specific toy was a small lego vehicle with several minifigs and while he jumped right into assembling the figurines, he stated that the vehicle was too hard and that he wasn't good at following the instructions. ![]() While mansitting my faux nephew (mansitting because he's not a baby and faux nephew because although my title is "Uncle BALES," we aren't actually related), I noticed a gap between his desire for creative play and his actual skill set. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |